Balmoral 10000 litre Complete Rainwater Harvesting garden system above ground. The Balmoral surface mounted rainwater storage system is supplied as a kit for horticultural, agricultural or garden use.

Why buy this system?

• Above ground location so no excavation required
• Big 10,000 litre tank for greenhouses, small holdings, larger gardens
• Filtered rainwater with built in overflow
• Powerful pressure sensitive pump for immediate delivery to the tap
• Trusted manufacturer of single piece tanks

The illustration above shows a typical installation with incoming water filtered by the Rainus filter and the excess water collected by the overflow syphon and drained back to a downpipe. The pump will deliver the stored water at pressure to irrigation units, ponds or larger tanks. This is particularly applicable where the delivery point is above the water level of the tank - e.g. garden with incline.

More about the tank

Balmoral, the trusted British brand, is a company that designs and manufactures rainwater storage tanks in the UK using the highly efficient rotational moulding process.

Rotational moulding is a process ideally suited to producing hollow plastic products. By using additional post-moulding operations, complex components can be produced enabling the process to compete effectively with other moulding and extrusion practices. Rotational moulding differs from other processing methods in that the heating, melting, shaping, and cooling stages all occur after the polymer is placed in the mould, therefore no external pressure is applied during forming. This provides the following advantages:

• Economically produced large products
• Minimum design constraints
• Very low residual stresses
• No polymer weld lines

The tanks have been rigorously tested to comply with the requirements of the United Kingdom Water Byelaws and Regulations when correctly installed.

About the pump

Rainwater Pump - HydroForce 800w submersible power pump - all the benefits of the new reliable UK manufactured HydroForce with built in pressure switch and run dry protection.

The all new HydroForce pump now has even more failsafe features:

• The internal electronics and PCB of the pump are now completely encapsulated in resin - so there is no chance of moisture ingress.
• The pressure switch has been upgraded for faster response times.
• The body moulding has been revised to prevent the effects of both positive and negative water pressure.
• The manufacturer's warranty is now extended to 2 years from date of purchase.
• Dry run sensor
• High volume 1 litre inline filter included to filter water as it enters the pump.

Rainwaterharvesting.co.uk has collated the components that are needed to divert water to the tank, filter out debris and retrieve it for uses from power washing to irrigation.

For do-it-yourself installation instructions in pdf form please click here

Other tank sizes?

Mainland UK  DELIVERY INCLUDED- LIFTING EQUIPMENT REQUIRED ON SITE FOR DELIVERY OF THIS ITEM. Since mid 2011 de,livery has been by 55 foot articulated lorry. Please ensure your approach roads are straight and wide. Thank you.